Versions Compared

Version Old Version 3 New Version 4
Changes made by

Krishtof Korda

Krishtof Korda

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

This article will explain how to connect a GPS/GNSS to your Ouster sensor and synchronize the Ouster sensor timestamp.

...

  1. Connect the PPS output from your GPS to the sync_pulse_in pin of the Ouster Interface box.

    1. Pictured here in yellow

  2. Connect the NMEA UART output from you GPS to the multipurpose_io pin of the Ouster interface box

    1. Pictured below in magenta

  3. Connect the ground output from your GPS to the GND pin of the Ouster Interface box.

    1. Pictured here in gray

Info

Please note the Voltage and Current requirements from the User Guide in Table 1 and Table 3 below.

...

Configuring the Ouster Sensor

...